Materials
eSUN ABS+
Improved-toughness ABS; enclosure needed to control warping.
Verified November 2026 · eSUN data sheetPrint settings
- Nozzle temperature
- 230–250°C
- Bed temperature
- 95–110°C
- Density
- 1.04 g/cm³
- Length per kg (1.75 mm)
- ≈ 400 m
- Enclosure
- Recommended
- Drying
- 70°C for 6 h
- Typical price
- $19 per kg
About ABS
Heat resistant and machinable but warps; needs an enclosure and ventilation.
Getting good results with eSUN ABS+
- Start near the middle of the range (240°C) and print a temperature tower to find your printer's sweet spot.
- Faster printing needs a hotter nozzle; slow, detailed prints look best near the low end of the range.
- Use an enclosure and keep drafts away to prevent warping and layer splits.
- Dry it (70°C for 6 h) if you hear popping, see extra stringing, or the surface turns rough.
Plan a print with the print cost calculator or convert meters to grams with the filament converter. Always check the label on your spool, since makers update their recommendations.