Materials
eSUN eTPU-95A
Flexible filament; disable or reduce retraction on Bowden setups.
Verified November 2026 · eSUN data sheetPrint settings
- Nozzle temperature
- 200–220°C
- Bed temperature
- 40–60°C
- Density
- 1.21 g/cm³
- Length per kg (1.75 mm)
- ≈ 344 m
- Enclosure
- Not needed
- Drying
- 60°C for 6 h
- Typical price
- $28 per kg
About TPU
Flexible and abrasion resistant. Print slowly; direct drive extruders handle it best.
Getting good results with eSUN eTPU-95A
- Start near the middle of the range (210°C) and print a temperature tower to find your printer's sweet spot.
- Faster printing needs a hotter nozzle; slow, detailed prints look best near the low end of the range.
- No enclosure needed; keep part cooling on after the first few layers.
- Dry it (60°C for 6 h) if you hear popping, see extra stringing, or the surface turns rough.
Plan a print with the print cost calculator or convert meters to grams with the filament converter. Always check the label on your spool, since makers update their recommendations.